Hi,
Has anyone fitted an inclined orbit elevation actuator to a 1.8m channel master dish on an Az-El mount or got any suggestions about how to go about doing this?
I assume there might need to be a bit of improvisation and fabrication of metal brackets or plates to get the elevation actuator to replace the threaded elevation bolt. I am not sure if direct replacement of the threaded elevation bolt at its location would be the best place to fit the elevation actuator though?
Any advice most...
Inclined Orbit Elevation Actuator on Channel Master 1.8m ?
Has anyone fitted an inclined orbit elevation actuator to a 1.8m channel master dish on an Az-El mount or got any suggestions about how to go about doing this?
I assume there might need to be a bit of improvisation and fabrication of metal brackets or plates to get the elevation actuator to replace the threaded elevation bolt. I am not sure if direct replacement of the threaded elevation bolt at its location would be the best place to fit the elevation actuator though?
Any advice most...
Inclined Orbit Elevation Actuator on Channel Master 1.8m ?