Today I finished for a Dutch board member , a lnb changer for a Gibertini 1.5 m .
Used a new alu rectangular 20 x 30 mm tube leaving the original feedarm unharmed .
Managed to use the original side-arms without any modification .
Of course with strengthening at the backside since the cross lines already did not touch at the start .
![GIBI 150 changer.jpg]()
![GIBI strengthening.jpg]()
Used a new alu rectangular 20 x 30 mm tube leaving the original feedarm unharmed .
Managed to use the original side-arms without any modification .
Of course with strengthening at the backside since the cross lines already did not touch at the start .
