Hi, just a little confused on how to configure the following, if i was to go down this route to replace an ageing 36v system on my 4 dish setup
4 Way disecq switch as follows works now, but LNB2 is on the 36V motor dish separate fed voltage at the moment
LNB1 Fixed 28E
LNB2 Motorized for possible new Disecq motor
LNB3 Fixed 19E
LNB4 Fixed 13E
I have read you need to position the switch after the motor for it to work, does this mean cable from receiver goes direct to motor then out of...
Disecq switch and disecq motor config
4 Way disecq switch as follows works now, but LNB2 is on the 36V motor dish separate fed voltage at the moment
LNB1 Fixed 28E
LNB2 Motorized for possible new Disecq motor
LNB3 Fixed 19E
LNB4 Fixed 13E
I have read you need to position the switch after the motor for it to work, does this mean cable from receiver goes direct to motor then out of...
Disecq switch and disecq motor config
