I have a DiSEqC motor that has seized due to an error of mine I allowed the motor to move to 60 degrees east in DiSEqC 1.2
Now I cannot get it to follow the commands by the receiver it just moves to the East & stops there,
I have tried USALS 1.3 & DiSEqC 1.2 but with no response from the motor like a supermarket trolley just goes where it wants too rather than where the STB tells it to go,
I have stripped it down & manually moved it to Zero 0 degrees soon as I connect it to the Lnb it goes...
Stab DiSEqC Motor not following STB commands
Now I cannot get it to follow the commands by the receiver it just moves to the East & stops there,
I have tried USALS 1.3 & DiSEqC 1.2 but with no response from the motor like a supermarket trolley just goes where it wants too rather than where the STB tells it to go,
I have stripped it down & manually moved it to Zero 0 degrees soon as I connect it to the Lnb it goes...
Stab DiSEqC Motor not following STB commands